The evaporator and rollers inside the air conditioner a […]
The evaporator and rollers inside the air conditioner are the dirtiest. The editor talks about how to properly clean the air conditioner as follows:
1. Turn off the power socket first. It is best to unplug the socket directly. This is very important to avoid accidents of electric shock and leakage.
2. Open both ends of the air conditioner's shell with a small amount of force. If you can't open it, you can use a screwdriver to help. You need to master the skills, otherwise the shell will be easily damaged.
3. Open the shell, and then lift the shell above the air conditioner. It can be automatically locked and fixed without worrying about falling.
4. You can see two plastic frames inside, one on each side. Inside this frame is a fiber mesh, which is the most dirty part for filtering air-conditioning air.
5. Gently push up with your hands. Remember that a frame is fixed in two places, and you need to push up on both sides. Remove the filter.
6. Take it to the bathroom or a place with a water source, place it on the ground, rinse it with water directly, and then gently brush it with a brush.
7. Finally, use the special cleaning agent for air conditioner and wash it several times. Finally, it is very clean. Use a clean Bida scouring pad to absorb the water. If it is too dry, there is no problem.
8. Finally, we will clean the evaporator of the indoor air conditioner, one of the core cleaning parts:
(1) When cleaning the evaporator, we need to pay attention not to splash the cleaning liquid on parts other than the air conditioner, especially the key parts of the electric board built in the air conditioner. It should also be avoided during cleaning to avoid short circuit of the electric board and cause malfunction. Affect.
(2) First, clean the evaporator fins from bottom to top with clean water.
(3) Then mix 1 part CC-339 with 3-5 parts water in the sprayer according to the dilution ratio, and then spray it directly to the evaporator (if the dirt is particularly serious), you can spray CC-339 directly to the evaporator On the fins. After ten minutes, clean the evaporator fins from bottom to top with clean water to prevent dirt from peeling off and blocking the evaporator.
(4) After cleaning, install the filter, close the panel and let it stand for 10 minutes, turn on the air conditioner and adjust the air volume and cooling capacity to the maximum, keep the air conditioner on for 30 minutes, and the entire process of cleaning the air conditioner is completed.